Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.2.12 Temperature
Range
Input
Ambient Temp ±2 digits
º
º
0 -1 OOO
C 4 00
C
º
1 _ 0 _ 0 _ 0 _
_ C __ -+- ± _ 5 _ d _ i _ g _ its _ --i ± ( 1 . 0 % of read ing
r-- -- +-
Ambient Temp ±2 digits
º
º
32-1832
F 800
F
º
1800
F
4. Using the Meter
4.1 Data Hold
4. 1 .1 During a measurement, press the "HOLD" button
once to hold the reading.
4. 1 .2 Press "HOLD" again to ralease the hold.
4.2 Manual Range
4. 2 . 1 In voltage, current, resistance and capacitance
modes, the default range is "AUTO"
4. 2 . 2 Press "RANGE" to enter manual ranging. E ach
press switches to a higher range. P ressing the
button at the highest range will return to the lowest
range.
4. 2 . 3 Hold "RANGE" to return to "AUTO"
4. 2 . 4 Pressing "RANGE" in Max/Min mode will return the
meter to normal reading.
Note: Manual range is disabled in frequency mode.
4.3 Relative Measurement Mode Switch
4. 3 . 1 Press "REL.6. to enter relativa measurement. T his
will store the reading when pressed and display the
difference between current reading and the stored
reading.
Test Range Accuracy
±4 digits
+3 digits)
±4 digits
±2 0 digits
15
4 .3.2 Press "REL.6." again to return to normal.
4.4 Maximum/Minimum Reading
4. 4 . 1 Press "MAX/MIN" to display the maximum value
recordad
4. 4 . 2 Press "MAX/MIN" again to display the mínimum
value recordad.
4. 4 . 3 Hold "MAX/MIN" to return to normal readings.
4.5 Function Switching
4. 5 . 1 In voltage or current modes, press "FUNC" to
switch between AC and DC.
4. 5 . 2 In resistance, diode or continuity modes, press
"FUNC" to switch between measurements.
4. 5 . 3 In temperatura mode, press "FUNC" to switch
º
º
between
C and
F.
4.6 Backlight
4. 6 . 1 Press "-: +: - " to turn on backlight. P ress again to turn off.
4. 7 Automatic Power-off
4. 7 . 1 lf there is no operation for 15 minutes after turning
the machina on, the meter will automatically power
off to save the battery.
4. 7 . 2 After automatic power-off, press any key to turn the
meter on again.
4. 7 . 3 Holding the "FUNC" key when powering on will
cancel automatic power-off function.
4.8 Non-Contact Voltage Detection (NCV)
4. 8 . 1 With the rotary switch in any position except OFF ,
hold down the "NCV" button.
4. 8 . 2 Move the tip of the meter near the voltage source
or conductor. lf the voltage detectad is greater than
11 OVAC, the buzzer will beep and the NCV indicator
near the tip of the meter will flash.
16
Publicidad
Tabla de contenido
