Wet/Dry Vac Assembly; Insert Hose - RIDGID WD1456BR0 Manual Do Usuário

SP6824 WD1455BR0 PSE

Wet/Dry Vac Assembly

1. Position the powerhead assembly on
the drum/caster foot assembly as
shown (assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum
Latch
Powerhead
Assembly
Latch
Drum
4/19/12 2:22 PM
Drum
Latch
Drum
Flange
45
Page 45

Insert Hose

Insert the push button end of the "Dual-
Flex™ Locking" hose into the inlet of the
Vac. The hose should snap into place.
To remove the hose from the Vac, press
the release button in the hose assembly
and pull the hose out of the Vac inlet,
as shown.
Press Release
and Button
Pull