Installation Steps - Ovislink Air Live WLA-5200AP Manual Del Usuario

Installation Steps

1. Please install your network cards first before the AP
2. Screw-in the antenna (clockwise) into the Antenna connector
3. Connect the power and LAN cable to the back
4. Use your wireless card to do a site survey, the default SSID is airlive
5. If you need to change AP's configuration, please follow the procedure
below:
The Client mode's default IP address is 192.168.1.254 Please
make sure your computer IP is in the same subnet as the AP (i.e.
192.168.1.x)
Open the web browser and enter 192.168.1.254
Enter the default user name airlive and password
Wireless mode setting
This page includes all primary and major parameters for wireless mode
setting. Any parameter change will cause the device to reboot for the new
settings to take effect.
Wireless Modes: AP, Client, Bridge, WDS Repeater, Universal
The default is set to AP mode. You can select to change it to other modes.
Network Type: When in Client mode, you can select between Ad-Hoc
and Infrastructure
Repeater Type: When in Repeater mode, you can select between
WDS Repeater and Universal Repeater
WISP Type: When in WISP mode, you can setup WISP(Client Router)
802.11 a/b/g Wireless AP
WLA-5200AP
Repeater, WISP (Client Router), and WISP +
Universal Repeater
"
airlive"
English
4
4