Headboard Bracket Installation Guide Optional - Ashley M9X432 El Manual Del Propietario

Headboard Bracket Installation
Guide (Optional)
Headboard brackets are an optional accessory and are not included.
A 1/2'' (13 mm) socket and 1/2'' (13 mm) wrench are necessary to complete installation.
(2) T-Brackets
(2) Headboard Brackets
STEP 1
a) Align the hole in the bracket to the sleeve into which the leg
threads. Hold the bracket in place and screw the leg into the
foundation until it is snug. DO NOT OVERTIGHTEN. Too much
force may cause the leg to spin freely.
b) The headboard bracket will have 2 tabs to accomodate any frame
type. Align the appropriate tab on the bracket with the hole on the
foundation. Use a M8*16 bolts and a nut to secure the bracket.
Make sure the bolt is tight.
STEP 3
You may now connect your headboard to the attachment plates using the remaining short bolts and nuts to secure it to the brackets. The heads
of the bolts will face outward. Use a 1/2'' (13 mm) socket and 1/2'' (13 mm) wrench to tighten the bolts.
HEADBOARD BRACKET COMPONENTS
(2) Spacers (4) M8*40
Customer Service Toll Free: 1 ( 800 ) 477-2222
—09—
(4) 3/8-20.5 (4) M8*16
STEP 2
Attach the plastic spacer and T-bracket.
a) Measure the distance between the mounting holes on the
headboard and install the spacer and attachment plate to
accommodate the headboard.
b) To install the plastic spacer and attachment plate, you will need
(2) M8*40 bolts and (2) nuts. Place the spacer and attachment plate
in the desired location and slip the bolts through the holes with the
head of the bolt facing outward. Position the bolts diagonally on the
spacer. Use the 1/2'' (13 mm) socket and 1/2'' (13 mm) wrench to
tighten the bolts.
(8) Nuts (2) Washers