PROBLEM
Shuts off before load is dry
Lint on clothes
Garments still wrinkled after
Wrinkle-Care
Odors remain in clothing
after Refresh.
Water drips from nozzle
when Steam-Care starts
Sprayed water is not visible
during Steam-Care
DV520AE-02836A_EN.indd 33
SOLUTION
•
Dryer load is too small. Add more items or a few towels and restart
the cycle.
•
Dryer load is too large. Remove some items and restart the dryer.
•
Make sure the lint filter is cleaned before every load. With some loads
that produce high amounts of lint, it may be necessary to clean the
filter during the cycle.
•
Some fabrics are lint producers (for example, a fuzzy white cotton
towel)and they should be dried separately from clothes that are lint
trappers(for example, a pair of lack linen pants)
•
Divide larger loads into smaller loads for drying
•
Check pockets thoroughly before washing and drying clothes.
•
Small loads of 1 to 4 items work best.
•
Load fewer garments.Load similar-type garments.
•
Fabrics containing strong odors should be washed in a normal cycle.
•
This is steam condensation. The dripping water will stop after a short
time.
•
Sprayed water is difficult to see when the door is closed
troubleshooting _33
2010-04-13 ¿ÀÈÄ 4:29:37