Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Oven Racks

Recommended rack positions for various types of
foods are provided in the Cooking Guide. Adjusting
rack position is one way to impact cooking results. For
example, if you would prefer darker tops on cakes,
muffins, or cookies, try moving food one rack position
higher. If you find foods are too brown on top try moving
them down next time.
When baking with multiple pans and on multiple racks,
ensure there is at least 1½" between pans to allow
sufficient space for air to flow.
flat racks.
To avoid possible burns, place the racks in the desired
position before you turn the oven on.
Extension Racks
Always pull the rack out by its upper front rail to its fully open
position, when placing or removing cookware.
If extension racks are difficult to extend, lubricate the racks
with the graphite lubricant provided with your oven. Remove
the rack from the oven, remove debris in the side tracks with
a paper towel, shake the graphite lubricant and place 4 small
drops on the two bottom tracks of the left and right sides. Open
and close the rack several times to distribute the lubricant.
To order additional graphite lubricant, see the Accessories and
Consumer Support sections at the end of this manual.
To Remove An Extension Rack:
1. Make sure the rack is pushed all the way into the oven
so that side paddles on the rack disengage from the oven
support.
2. Slide the rack toward you to the bump (stop position) on the
rack support.
3. Firmly grasp both sides of the rack frame and the sliding
rack, tilt the front end up and pull it out.
To Replace An Extension Rack:
1. Firmly grasp both sides of the rack frame and the sliding
rack.
2. Place the curved end of the rack (stop-locks) onto the oven
supports, tilt up the front of the rack and push it in as far as
it will go.
If extension racks are difficult to replace or remove, wipe
the oven rack supports with cooking oil. Do not wipe oil
on the rack slides.
To Lubricate the Paddle:
Shake lubricant and apply to the moving parts of the paddle
mechanisms as shown.
49-2000387 Rev. 0
The number of rack positions may vary by model.
Fully Open Position
Grasp here
Upper Front
Rail
15

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Chs90xm

Tabla de contenido