Front View; Rear View - Work Pro WNC 1 Guía Rápida

EN
DESCRIPTION
WNC 1 is a wall-mount controller that allows to associate to a Digiline device (Digiline 8 or
common LAN and control two basic parameters such as matrix of input sources selection and output gain.
Through WORKCAD software, you can configure a WNC 1 to a specific output or outputs and control
remotely these two magnitudes
Due to WNC 1 and DIGILINE use a common software for setup and managing, the integration is complete. The
process of associating a WNC 1 is very fast and intuitive through this software, being able to reassign the
at any time.
WNC 1 works with the concept "STATE". A STATE is defined as a preset in which the matrix selection of input
source on each output is configured. WNC 1 has 8 STATES to set, allowing navigate between them using the
appropriate buttons and enable or disable at will.
The 8 LED in the STATE paragraph will lit when the corresponding STATE is on (during about 1 second),
then the device will show that inputs are activated at that time illuminating the corresponding LEDs.

FRONT VIEW

1
2
1. Use the
of state will illuminate for 1 second, then the LEDs will lit according to the inputs associated in the current
STATE.
2. LAN LED: This LED will lit when the unit will be connected to a LAN.
3. Use the buttons to increase or reduce the output volume. The level will be indicated by the
associated LEDs. Its level will be fixed between +10dB to -40 dB. One point more of this value will be the
unit enter in MUTE state.
Quick Guide
buttons to select the desired STATE from 1 to 8. The LED corresponding to the number
- 1 -
4
3
5
Included
WNC 1
Digiline MX) on a

REAR VIEW

LAN
+ 5V DC
GND
www.work.es
RED pin