Peavey Classic 30 Manual Del Usuario página 7

ENGLISH
Classic 30
®
All-Tube Guitar Amplifier
Congratulations on your purchase of the Peavey Classic 30. This newest member of the Classic tube amp family uses the same
basic preamp design as the Classic 50, with the addition of the boost switch. The 30 watt power amp, when combined with the
specially-voiced 12" speaker (Combo only), creates a very powerful amplifier that's portable enough for backstage or practice,
yet loud enough to jam with a rhythm section. The dual channel preamp allows quick variation of tone— from vintage blues,
to modern hard-rock and grunge tones. The boost switch is particularly useful in obtaining the more traditional "cranked-amp"
tones without the harshness generated by sending too much low end to the power amp. The 30 watt power level is just the
right amount for power amp chunk and sustain at a reasonable volume.
Two particularly modern additions to this amplifier are the reverb and effects loop. The reverb unit is the long-spring type
found in most guitar amps since the 50's. The effects loop comes in especially handy when used with delay, chorus, and many
other effects units, racks or stomp boxes—when you don't want the associated noise of connecting them in-line with the amp.
For a special treat, try plugging one of the Classic enclosures or even a 412-Peavey 6505™ cabinet into the external speaker
jack. You'll find this particular combination has plenty of "knock" in the low-end. And best of all, it's very LOUD.
FEATURES:
• All-tube preamp and power amp
• 30 W RMS into 16 or 8 ohms (16 ohms only on Head)
• Tweed-covered cabinet with chrome chassis
• Lead and Normal channels: footswitchable (not included)
• Three-band vintage EQ
• External speaker capability
• Reverb with level control: footswitchable
• Effects loop
• Boost switch
Ventilation: Allow 24" of clearance on all sides from a combustible surface.
7