Control Panel - Caple TBU850 Manual Del Usuario

WORKING

Control panel

A: Light switch On/Off
B: Reduce speed / OFF motor
C: Motor speed display
D: ON motor/increase speed
E: 10 - minute timer
The touch control key allows the function
desired by touching the relative key.
If the electrical power supply to the
product is cut, 15 seconds are needed for self
diagnostics after the functions are restored.
In the meanwhile, its operation may be
incorrect.
The products are
electronic device which allows the automatic
switching off after 4 hours working from the
last operation.
TIMING
As a result of the new EU65 "Energy label"
and EU66 " Ecodesign" regulations issued
by the European Commission, which came
into force as from January 1st, 2015 , our
products have been adapted to comply with
these new re-quirements.
All of the models complying with the
energy label requirements, are equipped
with new electronics including a timer device
for suction speeds control, when the air
capacity exceeds 650m³/h.
Internal motor models, with maximum
air capacity higher than 650m³/h, are
equipped with
automatically switches the suction speed
from 4th to 3rd speed, after 5 minutes
operation.
The energy consumption of the appliance in
stand – by mode is lower than 0.5W.
endowed with
a timer device
MAINTENANCE
* An accurate maintenance guarantees good
functioning and long-lasting performance.
* Particular care is due to the grease filter
panel. It can be removed by pushing its
special handle toward the back-side of the
cooker hood and turning the filter downwards
so to unfasten it from its slot (Fig. 4).
To insert the filter just perform the opposite
operation.
After 30 hours working (model), the control
panel will signal the saturation of the grease
filter by lighting all the buttons. Press the
timer button to reset
The grease filter needs cleaning by regular
hand-washing or in dishwashers every two
months at least or depending on its use.
* In case the appliance is used in its filtering
version, the active charcoal filter (Fig. 12)
needs to be periodically replaced. The charcoal
filter can be removed by removing the grease
filter first (Fig. 4), and by pulling its special
plastic tongue until it is unfastened from its
slot. Re-insert the charcoal filter by operating
an
in the opposite way. The charcoal filter needs
replacing depending on the use, but we
recommend every six months at least. To
purchase replacement filters, please visit
www.caple.co.uk or call our sales office 0117 938
1900
* To clean the appliance itself tepid water and
neutral detergent are recommended, while
abrasive products should be avoided. For
steel appliances specialized detergents are
recommended (please follow the instructions
indicated on the product itself to obtain the
desired results).
LED BAR REPLACEMENT
To remove the led bar, it is recommended to
remove the steel bar as shown in Fig. 6 and 7,
then disengage the led bar by acting on the
specific fastening springs.
Replace the led bar with one of the same
characteristics and then refit the steel bar.
that
* If the supply cord is damaged, it must be
replaced by the manufacturer or its sevice
agent or a similarly qualified person in
order to avoid a hazard.
13
.