SICK M4000 Manual Del Usuario página 66

Operating
Instructions
Device Column
with Heater
66
8008738/QG60/2006-10-20 © SICK AG • Industrial Safety Systems • Germany • All rights reserved
Installation and Electrical Connections
5. Fasten M4000 or M2000 with the swivel mounting brackets to
the slots on the side of the device column. Between top edge
of column and swivel mount bracket for the multiple light beam
safety device leave a space of approx. 50 mm (for 3-beam
M4000), 250 mm (for 2-beam M4000), 55 mm (for 3-beam
M2000), 255 mm (for 2-beam M2000). Swivel the mounting
brackets (or rotate the entire device column) to align the sender
and receiver. See also relevant Operating Instructions.
6. Slide the Plexiglas front screen (with heater) together with the
connector into the grooves of the device column. To plug in the
heater connector raise the screen slightly, placing a support
underneath it if necessary. After plugging in the connector, clip
it into the holder at the side.
7. Screw the housing cover back on.
8. Installation is complete.
Chapter 4