Frequently Asked Questions; Charging Base - Bagotte BG800 Manual Del Usuario

5.2 Frequently asked questions

Problems
Robot cannot be
activated.
The remote control does
not work.
Robot stops working
suddenly.
You cannot schedule
cleanings.
Suction power is weak.
Robot cannot be
charged.
Solutions
• Make sure the main power switch is in the ON position.
• Make sure the battery is fully charged.
• Replace the batteries (2 AAA) in the remote control.
• Make sure the remote control is within range (16 ft/5 m) of robot.
• If you still have trouble,turn o the main power switch,wait then turn it
back on.
• Replace the batteries in the remote control.
• Make sure Robot is turned on and fully charged.
• Check if robot is trapped or stuck on an obstacle.
• Check if the battery level is too low.
• If you still have trouble,turn o the main power switch,wait for 2 seconds
and then turn it back on.
• Make sure the main power switch on the bottom of robot is turned on.
• Make sure the time, time of day (AM/PM), and the scheduled time have
been set correctly.
• Check if robot's power is too low to start cleaning.
•
Check if any obstructions are blocking the suction inlet.
•
Empty the dust collector.
•
Clean the filters with a vacuum cleaner or a cleaning brush.
•
Check if the filters are wet due to water or other liquid on the floor.
Air-dry the filters completely before use.
•
Check if the indicator on the Charging Base lights up.
If not, contact the bagotte service center to repair or replace the

Charging Base.

•
Dust o the charging contact pin with a dry cloth.
•
Check if you can hear a beep when robot is docked onto the
Charging Base.
If not, contact the bagotte service center to repair or replace the
Charging Base.
- 23 -
English