Circutor Wi-beee Manual Del Usuario página 16

Instructions
1
Before using Wi-beee ensure that the conditions
are the appropriate for working, and that the
protection equipment is the adequate.
1. Remove the protective panel.
2. Install the device, be careful with the
neutral terminal (N) this one must
correspond with the neutral cable
of your installation (your device
could be damaged if a bad installa-
tion is made).
3. Put the magnetics connectors in di-
rection to circuit breaker.
4. Press the device to ensure the en-
gage.
5. Put the conductor of each line close to the Wi-beee
body.
16