Operating Instructions; Start-Up - Mi-T-M Corporation CHV Serie Manual Del Operador

DANGER
risk of inJection causing
seVere inJury!
-keep clear of nozzle!
neVer place Hand or
f i n g e r s i n f r o n t o f
nozzle!
-do not direct discHarge
stream at people or
pets!
-be certain tHe nozzle
is securely connected
to tHe wand to preVent
accidental discHarge.
CAUTION
risk of damage.
do not allow spray
pattern to remain on
a fiXed area for an
eXtended period of time.
possible damage may
occur to tHe area.
6

operating instructions

START-UP:

. Refer to the "Safety Precautions" pgs. 4-7 before starting the unit.
2. Lay the high pressure hose out to remove any loops. Water flow will
constrict the hose creating tight loops if the hose is not straight.
3. Securely connect the gun/wand assembly to the high pressure hose.
4. Push the manual dump valve lever down so the pump will start in bypass
mode. Turn the water supply completely on.
5. The diaphragm pump will not suffer if run dry due to an empty tank.
However a "starved" suction due to a clogged strainer screen or a closed
suction valve will cause premature failure of the pump diaphragms.
Important: keep suction valve open whenever system is being operated
6. Move the toggle switch to the "ON" position and push the green start
button to turn on the unit.
7. Water will begin flowing through the bypass hose back to the water supply
tank. This allows the unit to prime and purge any air from the system.
The unit is primed when water flow is uninterrupted by air.
8. Return dump valve lever to the "UP" position.
9. Point the gun in a safe direction and squeeze the trigger. Brace yourself,
as the gun will kickback from the force of the water exiting the nozzle.
0. Once the unit is turned on, perform the following procedures with the gun
open:
a. Inspect for system water leaks and oil leaks. If a leak is found, TURN
the UNIT OFF! Be sure that all damaged parts are replaced and that
the mechanical problems are corrected prior to operation of the unit.
If you require service, contact Customer Service.
b. Inspect high pressure hose for kinking cuts and leaks. If a cut or leak
is found, DO NOT TOUCH HOSE AT CUT OR LEAK!!! TURN the
UNIT OFF! Replace hose before restarting the unit. Be sure that all
damaged parts are replaced and that the mechanical problems are
corrected prior to operation of the unit. If you require service, contact
Customer Service.
c. Inspect electrical cord for cuts. If a cut is found, DO NOT TOUCH
ELECTRICAL CORD AT CUT!!! TURN UNIT OFF IMMEDIATELY!
. Trigger the gun several times. NEVER look directly into the nozzle! High
pressure water creates a risk of severe injury!
Operator's Manual