Roadmaster 1991-1994; Caprice 1991-1993 - Dynex DX-G1113 Guia Del Usuario

Installing your car stereo
Buick

Roadmaster 1991-1994

Chevrolet

Caprice 1991-1993

To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the two screws from the driver-side service panel, then unclip the panel.
3 Pry off the trim piece located above the glove box, then remove one screw.
4 Remove three screws from the top edge of the dash trim bezel. Remove one screw
from the lower-left corner of the glove box and one screw from the parking brake
release.
5 Remove the dash trim bezel.
6 Cut and remove all mounting tabs on bracket 4 except the B tabs. Each mounting tab
has a letter stamped on the back of the tab. Cut the tabs with the blade pointed away
from you and your fingers.
7 Go to "Completing the installation" on page 76.
B
15