Installing your car stereo
Chevrolet
Cavalier 1982-1990
Cadillac
Cimarron 1982-1988
Pontiac
Sunbird J-2000 1982-1988
To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Remove the four star-drive screws from the dash trim bezel.
3 Remove the two star-drive screws from the left side of the instrument cluster, then
remove the dash trim bezel.
4 Remove two screws from the factory head unit, then remove the head unit.
5 Cut and remove all mounting tabs on bracket 4 except the A tabs. Each mounting tab
has a letter stamped on the back of the tab. Cut the tabs with the blade pointed away
from you and your fingers.
6 Go to "Completing the installation" on page 76.
A
A
33