How To Assemble Your Ceiling Fan - Fanimation The Celano Manual Del Propietário

1. Dis-assemble the Upper Housing Cover by loosening
three screws (Fig 1a) and carefully twist-n-lift off the Cover
(Fig 1b).
2. Attach blades to the motor hub using the provided
washer head screws and fiber washers. Make sure the
screws securing the blades to the motor hub are tight and
are properly seated. Do not overtighten.
(Figures 2a, 2b)
3. Re-assemble the Upper Housing Cover by securing the
Cover as shown (Figure 3) and do not over-tighten the
screws.
4. Remove the Hanger Ball by loosening the setscrew
in the Hanger Ball until the ball falls freely down the
Downrod. (Figure 4) Remove the Pin from the Downrod,
then remove the Hanger Ball. Retain the Pin and Hanger
Ball for reinstallation in Step 6.
5. The fan comes with blue, black, and white 80˝ wires.
Separate and untwist the three wires. Route the wires and
support cable through the Downrod.
NOTE: You will be using either the 6˝ or the optional
downrod purchased separately.

How to Assemble Your Ceiling Fan

Screw (3)
Figure 1a
Figure 2a
Hanger
Ball
5
Figure 1b
Figure 2b
Figure 3
Pin
Setscrew
Figure 4