Built-In Battery; Open The Package And Check; Connect The Power Cables - Gima CMS8000 Manual Del Uso

13
Warning
Through network interface only our company's Central Monitoring System can be connected in.

1.5 Built-in Battery

The Monitor is equipped with rechargeable batteries. The battery in the monitor can automatically recharge
when connected to AC INPUT until it is full. A symbol
screen to indicate the status of recharging, in which the YELLOW part represents the relative electric energy
of the battery. And, if the battery is not installed in the monitor, battery state will be displayed as
to indicate that no battery is available.
Under connectors to patient cables there are battery slots with cover. See Figure 1-4 Battery Slot Cover.
Warning
• Don't pull off battery during monitoring.
• Remove the battery if the ME EQUIPMENT is not likely to be used for long time.
• The battery shall be only applied on this device. Any maintenance or replacement upon the battery should
be processed by the service personnel trained and authorized by our company.
• When operating on battery, the monitor will prompt alarm and shut off automatically when the energy
is low. When the electric energy is going out, the monitor will sound continuous level 1 alarm beeping
and display "BATTERY LOW" in the Message Area. Connect the monitor to AC power at this moment
can recharge the battery while operating. If keep operating on the battery, the monitor will shut off
automatically (about 5 minutes since alarming) upon exhaustion of the battery.
Chapter 2
GettInG StArted
• Open the package and check
• Connect the power cables
• Power on the monitor
• Connect patient sensors
• Check the recorder
Note
To ensure that the monitor works properly, please read Chapter Patient Safety, and follow the steps before
using the monitor.

2.1 open the Package and Check

Open the package and take out the monitor and accessories carefully. Keep the package for possible future
transportation or storage. Check the components according to the packing list.
• Check for any mechanical damage.
• Check all the cables, modules and accessories.
If there is any problem, contact the distributor immediately.

2.2 Connect the Power Cables

Connection procedure of the AC power line:
• Make sure the AC power supply complies with following specification: 100-240V~ 50/60Hz.
• Apply the power line provided with the monitor. Plug the power line to INPUT interface of the monitor
(Socket 3 in Figure 1-4). Connect the other end of the power line to a grounded 3-phase power output.
Note
• Connect the power line to the jack special for hospital usage.
• Connect to the ground line if necessary. Refer to Chapter Patient Safety for details.
• Make sure that the POWER lamp now lights. If it does not light, check your local power supply.
If the problem still exists, contact the local Customer Service Center.
is displayed on the upper left quarter of the