Ironing Without Steam - Philips Azur Cordless HI575 Manual Del Usuario

C
2 Take the iron from the stand.
3 HI575 only: put the iron back on the stand when the
temperature light starts blinking. This indicates that the iron
has cooled down below the set temperature.
When you stop ironing for a while, always put the iron on the
stand to allow it to heat up again.
When you use the shot-of-steam or turbo-steam function, the
iron may cool down rather quickly. We advise you to iron in
corded mode when using these functions.
Steam ironing
1 Make sure that there is enough water in the water tank.
2 Select the recommended ironing temperature (see section
'Setting the temperature').
3 Put the iron on the stand.
C
4 Put the mains plug in the wall socket.
The iron starts heating up.
As soon as the water in the water tank is hot enough for steam
ironing, the temperature light goes out.
C
5 Set the steam control to the required position to start steam
ironing.
Steam ironing is only possible at higher ironing temperatures
(temperature settings 2 to MAX).
Select the recommended steam setting:
1 - 2 for moderate steam (temperature settings 2)
B
3 - 6 for maximum steam (temperature settings 3 to MAX)
B
During steam ironing the temperature light goes on from time to
time. This indicates that the iron is heating up to the set
temperature.

Ironing without steam

To iron without steam, proceed as described for steam ironing
but set the steam control to position 0 (no steam).
1 Select the recommended ironing temperature (see section
'Setting the temperature').
ENGLISH
11