Assembly & Operation; Before Operation - Worx HYDROSHOT WG625 Manual Del Usaurio

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY & OPERATION
ACTION

BEFORE OPERATION

Installing the battery pack
Removing the battery pack
Charging the battery pack
More details can be found in WA3742
manual
OPERATION
Attaching pressure cleaning lance to the
power nozzle
NOTE: When attaching, align the
two projections on the lance with the
grooves of the power nozzle as shown
in Fig. B
NOTE: The highest pressure is 320psi.
It is suitable for removing strong stains.
Attaching the multi-spray nozzle
NOTE: When attaching, rotating the
nozzle left and right to make sure the
nozzle fully seated into position and
gently pulling it to make sure it is
locked into position securely.
Attaching the draw hose to the power
nozzle
NOTE: After the draw hose is attached,
check the connection by gently pulling
upon the draw hose. It should not be
pulled off.
Attaching your own water hose
(optional)
1. Attach the quick connect adapter
2. Attach the home garden hose with
suitable connectors
NOTE: Except for the draw hose
supplied, you can also connect the
power nozzle to your own water hose
with suitable connectors.
NOTE: Check whether the filter screen
is missing before retightening the hose
adapter. (Fig. P1, P2) When retightening
the hose adapter, please tighten
securely. Otherwise, it may not draw
any water for proper operation.
WARNING: It is not
recommended to connect the
draw hose to your garden hose or
your home tap.
Cordless Portable Power Cleaner
Start
NOTE: At the first use, you need to
empty the air in hose, place the
power nozzle below waist level (<5ft /
1.5m), then attach the extension
lance and set it at high pressure. Do not
start working until the water
FIGURE
goes up along the hose and sprays out.
This could take up to 30
seconds or more depending on the
See Fig. A1 fresh water source.
See Fig. A2
Selecting the nozzle pattern
NOTE: Choose a suitable nozzle
pattern according to your work. Spray
See Fig. A3
patterns 0
applicable for cleaning, and the spray
pattern with the symbol
suitable for watering.
WARNING: Do not shift the nozzle
pattern when the tool is powered on.
Cleaning
See Fig. B
WARNING: Do not connect the
machine to water supplies that
are dirty, rusty, muddy, or corrosive.
(Including window cleaning liquids,
plant foods, or fertilizers etc.)
NOTE: Not recommended for use with
salt water, immediately rinse with fresh
See Fig. C
water for proper maintenance.
Watering
See Fig.
D1, D2
See Fig.
E, F
o o o o
, 15 , 25 and 40 are
is best
See Fig. G
See Fig. H
See Fig. I1
13
See Fig. I2
EN