Tabla de contenido
Publicidad
IMPORTANT!
adjust their height by turning the outer legs
10 and the inner legs 11 (pic. 2). When legs
are turned clockwise, the front of the
appliance is raised, when anti-clockwise, it is
lowered. Make sure that both appliances are
stable.
Connecting the appliances
Start connecting the appliances at the back.
1.
Separate one appliance from the other, leaving a gap of 7
mm inbetween.
2.
Unscrew the screws 12 at top of the backside of the
appliances (pic. 3).
3.
Screw back plate 6 at the back of the appliances (pic. 3).
Screw the screws 12 back in.
4.
Attach back plate 6 using self-tapping bolts 9 (from the bag)
where the designated holes are located (pic. 3).
5.
Carefully push the two appliances into their intended place.
We recommend doing this with someone's help, slightly
tilting the appliances backwards.
upper plate 4 (Qty: 1);
bottom plate 5 (Qty: 1);
back plates 6 (Qty: 2);
Before
starting
to
bolts 7 (Qty: 2);
self-tapping bolts 8 (Qty: 4);
self-tapping bolts 9 (Qty: 2);
(in the bag inside the freezer).
work,
Publicidad
Tabla de contenido
