Swing-N-Slide Alpine PROJECT 611 Manual De Instrucciones página 107

PROJECT 613 • PROJECT 614
Fig. 18
NOTE: Lay the lumber on a flat surface
before beginning laminated beam assembly.
Fig. 18a
NOTE: It is highly recommended
that screws be used when
laminating the Swing Beam.
Optional Laminated Beam
NOTE: Attach one end of the beam with three
2-1/2'' screws. Secure boards and attach the
other end with three 2-1/2'' screws. This will
insure that your boards will stay aligned
throughout the remainder of the beam assembly.
Stagger screws to
insure a sturdy
bond between
boards
K. Laminated Beam Instructions
1. If 4" x 6" lumber is not available, you may
laminate two 2" x 6" x 144'' pieces of lumber
together to create the beam.
2. Lay the lumber on a flat surface and align all of
the edges. NOTE: Make sure each piece of
lumber is the same length. If it is not, trim board(s).
3. From the end of each board, measure and place a
mark at 24" intervals (Fig. 18).
4. Assemble the beam by attaching each end
together using three 2-1/2'' screws (Fig. 18a).
Note: Stagger the screws as shown in (Fig. 18a) to
insure a sturdy bond. Repeat every 24" along the
entire length of the beam.When beam is complete,
measure, drill holes, and attach beam clamps and
nylon bushing swing hangers
35
614 614
613 613
24"