Installing The Canopy Housing; How To Assemble The Ceiling Fan Blades - Fanimation The Xeno FP6728 Serie Manual Del Propietário

NOTE: This step is applicable after the neccessary wiring
is completed.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)

How to Assemble the Ceiling Fan Blades

INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1. Position blades over the threaded posts secure with
the 3/16˝-24 screws and fiber washers. (Figue1)

Installing the Canopy Housing

WARNING
HARDWARE USED:
3/16 -24
SCREWS
FIBER WASHER
9
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
3/16˝-24 Screw with
Fiber Washer (3 per blade)
Figure 1
x 9
x 9