Filter Reset - GE PHC06 Manual Del Usario

Controls
elay
3. D
Delay ON—When the air conditioner is off, it can be
set to automatically come on in 1 to 24 hours at its
previous mode and fan settings.
Delay OFF—When the air conditioner is on,
it can be set to automatically turn off in 1 to
24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or the remote
control. Each touch of the Increase
pads on the unit or the remote control will set the timer
in 1-hour intervals.
To review the remaining time on the Delay 1–24hr
timer, press the Delay 1–24hr pad on the unit or the
pads on the unit or on the remote control to set a new
time if desired.
To cancel the timer, press Decrease
unit or the remote control until the set time is zero.
After 3 seconds the light on the Delay 1-24 hour pad
goes off.
49-5000295 Rev. 1
+
/ Decrease
+ –
Increase / Decrease
–
pad on the
4. TEMP/TIME
1. Press the TEMP/TIME
temperature. Each time you press the TEMP/TIME
+ button, the temperature will go up by 1° F until it
reaches 86° F (30° C).
2. Press the TEMP/TIME
temperature. Each time you press the TEMP/TIME
– button, the temperature will go down by 1° F until it
reaches 61° F (16° C).
NOTE
–
Dehum mode, the display will show the set temperature.

5. FILTER RESET

This feature automatically notifies you that the air filter
must be cleaned. The indicator light will come on after
240 hours of operation. Clean the air filter (refer to Care
and Cleaning section), place it back in the front panel,
and press the Filter Reset button. The light will turn off.
6. WiFi Connect
Enables connection of the air conditioner to hte home
WiFi. Download App for details at:
GEAppliances.com/connect.
+
button to raise the
–
button to lower the
5