Door Microswitch; Product Loading Procedure; Vending A Product - FAS 480 BUDGET Manual Del Usuario

14
7.2

DOOR MICROSWITCH

Normal functioning
Loading of products
E
Free sale
N
G
L
I
S
H
7.3

PRODUCT LOADING PROCEDURE

Once the machine has been commissioned, proceed as follows:
1) Open the main door.
2) Release by hand the solenoid corresponding to the disc to be loaded. Turn the disc.
3) If you want to let the discs turn automatically through the engine, insert the special key into the micro A
leaving B open.
ATTENTION: Inserting the key could cause the movement of some parts of the machine and this
operation must be therefore carried out by skilled workers.
4) After the loading make sure that the empty compartment of every drum is in front of the delivery door.
N.B. Make sure the products are not coming out from the edges of the drum itself.
7.4

VENDING A PRODUCT

After loading according to instructions in paragraph 7.3, setting the selling prices for each product,
filling the change tubes (if the machine is equipped with a change giving coin mechanism ), the machine is
ready to vend.
1) Insert the correct amount for the purchase.
2) Press the selection pushbutton corresponding to the chosen product.
3) Take the product from the compartment which has been automatically opened.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
There are two microswitches A/B on the left low reinforcement protected against the
fortuitous operations and which can be operated only through the proper equipment
key.
The A microswitch, which is in accordance to the rules, is used to switch off the
feeding from all the electric parts of the machine when the door is opened. If
necessary the feeding can be restored by inserting the proper key.
The B microswitch signals to the machine that the door is open. "REMOVE THE
KEY FROM THE ELECTRIC PANEL BEFORE CLOSING THE DOOR".
A B
Closed Closed
Closed Open
Closed Closed
SW1-1
OFF
OFF
ON
480 Budget - Issue 00