Blaupunkt PG3000 Manual De Instrucciones página 10

TROUBLESHOOTING
Little or no painting material being
sprayed
Material or paint
leaking
Atomisation too
course
Spray jet pulsates
Pattern runs
Too much overspray
WARRANTY
This product has 3 Years Warranty for manufacturing defects. The warranty period will be counted from the date of purchase
of the product, according to purchase invoice. Product warranty only covers manufacturing defects, defects resulting from
improper use, such as dropping, improper transportation, connection to the mains power supply not in compliance with the
voltage specified in this manual, insertion of foreign objects and natural wear of parts and parts Such as plastic parts (caps,
buttons, handles, latch locks, power cables, etc.) and metal parts (wires, motors, etc.).
Also not covered are damages due to agents of nature, lightning, food, sea, oxidation, humidity etc.). The product will lose its
warranty if it presents defects, which after analysis by our technicians, are characterised as being improperly used, used for
professional use or for the purpose for which it is not intended (according to the Owner's Manual). This warranty will be void if it
is found that the device has been tampered with, has been repaired by a person or service not authorised by Blaupunkt.
The guarantee is only valid with the receipt/invoice provided at purchase.
We undertake to provide the above-mentioned services within the warranty period only in places where it maintains an
authorised service. Consumers not located near an authorised service centre are responsible for the costs and risks of transport
to an authorised service.
Territorial Limitations: Any repair, replacement, or support of the Products provided under the Warranty (or any other support
service offered in our sole discretion), shall be restricted to, and provided solely within, the Distribution Territory as then in effect
on the date the Product is delivered to you. If you purchase a Product within a defined Distribution Territory and later transport
the Product outside of the Distribution Territory, we cannot provide returns, warranty, out-of-warranty, or aftermarket support of
any kind outside the Distribution Territory.
Natural 'wear and tear' is not covered under warranty.
This product is for domestic use only.
Nozzle
Suction tube clogged
Material volume setting turned
too low (-)
Suction tube loose
No pressure build-up
Air filter clogged
Nozzle loose
Nozzle worn
Nozzle seal worn
Material build-up on air cap
& nozzle
Viscosity of material too high
Material volume too large
Material volume too high (+)
Nozzle clogged
Air filter clogged
Too little pressure build-up in
the container
Material in container is running out
Air filter is clogged
Spray material is too viscous
Applying too much painting
material
Gun too far from spray object
Too much painting material
applied
Clean
Clean
lncrease paint volume
Re-insert tube
Tighten container
Change
Tighten
Replace
Replace
Clean
Thin material by 10%
Decrease paint volume(-)
Decrease paint volume(-)
Clean nozzle
Clean or change
Tighten container / check seal
Refill container
Clean / replace
Thin material by 10%
Decrease paint volume setting (-)
Reduce distance from object
Decrease paint volume setting (-)
S
Th
Th
C
W
of
Pr
Br
M
Is
M
EM
RO
Us
EN
EN
EK
EN
EN
EN
EN
Gu