Application And Operation; Changing The Blank Holder - IDC Mikro Modo De Empleo

6

Application and Operation

WARNING:
Danger from shavings/chips or tool fragments
being thrown from the machine!
▷ Make sure that the door of the milling machine
is always closed during processing!
NOTE:
Insufficient milling results and increased wear
when dry processing!
▷ Do not operate the milling machine without
extraction!
6.1

Changing the blank holder

In delivery condition, the milling machine is
equipped with a 71 blank holder.
To change the blank holder:
▷ With the door closed, press operation button [A]
for at least three seconds.
The current tool is placed down. The blank
holder [2] moves to the change position.
1
Fig. 9
1 Fastening screw for blank holder
2 Blank holder
▷ Loosen fastening screw [1].
A P P L I C A T I O N A N D O P E R A T I O N
▷ Pull off the blank holder toward the right.
▷ Clean the locating bore and surfaces.
▷ Check the pin of the blank holder and clean if
required.
▷ Insert the blank holder with the pin to the stop
in the locating bore.
NOTE:
Inaccurate working results or damage to the
blank-holder fixture possible!
▷ Tighten fastening screw [1] with a torque of
4 Nm.
The torque wrench included in the delivery
scope is appropriately set.
▷ Tighten fastening screw [1] with with the sup-
plied torque wrench.
▷ Briefly press operation button [A].
The machine advances to the starting position.
2
E N
33