Hood Safety Switch Operation Check - Clarke RSW 37 Libro De Instrucciones

ENGLISH
Front and rear skirt check
1. Remove the main broom, as shown in the relevant paragraph.
2. Check the front (A, Fig. 20) and rear skirts (B) for integrity.
3. Replace the skirts when they have cuts (A, Fig. 17) larger than 0.8 in (20 mm) or cracks (B) larger than 0.4 in (10 mm) (for
skirt replacement, refer to the Service Manual).
4. Check that:
• The front skirt (A, Fig. 20) slightly touches the fl oor (A, Fig. 19).
• The distance from the ground of the rear skirt (B, Fig. 20) is within 0 – 0.1 in (0 – 3 mm) (A, Fig. 18).
5. If necessary, adjust the skirt height by using the slots (C, Fig. 20).
6. Press the front skirt lifting pedal (8) and check that the front skirt (A, Fig. 21) turns upward for about 90° (as shown in the
fi gure); then release the pedal and check that the skirt does not remain in an intermediate position but returns to its initial
position. If necessary, for the front skirt control cable adjustment or replacement, refer to the Service Manual.
7. Assemble the components in the reverse order of disassembly.
> 0,4 in
> 0,8 in
B
Figure 17
C
A
Figure 20

HOOD SAFETY SWITCH OPERATION CHECK

With the vacuum fan turned on, slightly open the hood (10) and check that the fan immediately turns off.
If the vacuum fan does not turn off when the hood (10) is open, contact an authorised Service Center or Retailer immediately.
20
A
A
S310037C
C
B
S310040C
0 - 0,1 in
S310083C
Figure 18
Operator's Manual - RSW 37
A
Figure 19
A
Figure 21
S310084C
S310085C