Maintenance & Adjustment; Maintenance Schedule - Troy-Bilt Super Bronco Manual Del Propietário

Maintenance & Adjustments

Maintenance Schedule

Clean Hood/Dash Louvers
Check Engine Oil Level
Check Air Filter for Dirty, Loose or Damaged Parts
Clean and Re-oil Air Filter's Foam Precleaner
Replace Air Filter Element
Change Engine Oil and Replace Oil Filter
Clean Battery Terminals
Lube Front Axles and Rims
Clean Engine Cooling Fins
Lube Front Deck Wheels
Lube Deck Spindles
Lube Pedal Pivot Points
Check Spark Plug Condition & Gap
Replace Fuel Filter
Maintenance
WARNING!
Before performing any maintenance or
repairs, disengage PTO, set parking brake, stop
engine and remove key to prevent unintended
starting.
Engine
Refer to the Engine Owner's Manual for all engine maintenance
procedures and instructions.
NOTE: Maintenance, repair, or replacement of the emission
control devices and systems which are being done at owner's
expense may be performed by any engine repair establishment
or individual. Warranty repairs must be performed by an
authorized service dealer.
Before Every Every
Each use 10 Hours 25 Hours
P
P
P
P
P
P
P
P
P
P
Changing the Engine Oil
NOTE: The oil filter should be changed at every oil change
interval. To complete an oil change, proceed as follows:
1. Run the engine for a few minutes to allow the oil in the
crankcase to warm up. Warm oil will flow more freely and
carry away more of the engine sediment which may have
settled at the bottom of the crankcase. Use care to avoid
burns from hot oil.
2. Open the tractor's hood and locate the oil drain port on the
right side of the engine.
Every Every
50 Hours 100 Hours
P
P
P
P
WARNING!
If the engine has been recently run, the
engine, muffler and surrounding metal surfaces will
be hot and can cause burns to the skin. Exercise
caution to avoid burns.
6
Prior
to Storing
P
P
P
P
P
P
P
P
19