Electrolux EPI09LEIW Manual De Instrucciones página 13

The remote control does not
work.
Water leakage in indoor unit.
Water leakage in outdoor unit.
Noise from indoor unit.
The indoor unit cannot blow air.
Moisture on air outlet.
If one of the following code
appears on the display area :
E0,E1,E2,E3...or P0,P1,P2,P3...
There is harsh sound during
operation.
Strong odours are emitted during
Is there any magnetic or electrical
interference near the unit? If yes, remove
and reinsert the batteries.
Is the remote control within its transmitting
and receiving range without any
obstructions? If necessary, replace the
batteries.
Is the remote control damaged?
The room humidity is high.
Condensing water overflows.
The drain hose is loose.
In COOL mode, water condensate is
generated around the pipes and connection
joints.
In HEAT mode, the water on the heat
exchanger drips out.
In defrost mode, the thaw water flows out.
The noise emitted when the fan or
compressor relay is switched on or off.
If the defrost mode is started or stopped, you
will hear the sound of refrigerant flowing in
the reverse direction.
In HEAT mode, when the temperature of the
indoor heat exchanger is low, the airflow is
stopped within a few minutes in order to
prevent cold air.
In HEAT mode, when the outdoor
temperature is low or the outdoor humidity is
high, frost will be formed on the outdoor heat
exchanger. The unit will defrost automatically
and the indoor unit will stop blowing air for 4-
10 minutes.
In defrost mode, water or vapour may be
emitted.
If the unit operates at high humidity for a long
time, moisture will be generated on the grill
of the air outlet.
Stop the air conditioner immediately,
disconnect the power and then connect it in
again. If the problem still exists, disconnect
the power and contact the nearest customer
service center.
Immediately stop operation, disconnect the
unit from the power supply and contact an
authorised service centre.
Immediately stop operation, disconnect the
ENGLISH 12