Plug In The Power Cord And Push The Power Switch On; Set The Brightness And Contrast Controls - Boundless VGB10 Información De Instalación Y Funcionamiento

Plug in the power cord and push the power switch on

The terminal will beep indicating that the power is on.

Set the Brightness and Contrast controls

If necessary, set the brightness and contrast controls by doing the
following:
1. Set both controls to maximum by turning controls all the way
to the right.
Adjust the brightness control
2.
left until the background raster is not visible. This sets the
black level.
Adjust the Contrast control
3.
left to set the white level for conformable viewing.
Repeat steps 2 and 3 as needed.
4.
Install your terminal
•
by turning the control to the
Œ
by turning the control to the
1-3