Problems, Causes And Remedies - Zhermack SAB 1000 Manual De Uso Y Mantenimiento

WARNINGS
9.1
Should any of the anomalies described below occur try setting the situation right, as
far as is permissible, by following the instructions contained in this handbook.
Should the problem persist contact your Authorised Servicing Centre.

PROBLEMS, CAUSES AND REMEDIES

9.2
p
roBlem
With the main
switch set to ON
the aspirator does
not work.
The aspirator motor
jams.
102 of 136
CHAPTER 9: TROUBLESHOOTING
C
ause
1. The aspirator plug is not
correctly inserted in the
sandblaster socket.
2. The sandblaster power lead
is not properly inserted in the
socket or is faulty (bare,
damaged wiring
1. The paper bag filter is full.
MAINTENANCE AND USE MANUAL
EN
1. Check that the plug is inserted
properly.
2. Replace the power lead.
Contact an Authorised Assistance
Centre only.
etc.).
1. Change the paper bag filter.
If the problems persists contact an
Authorised Service Centre.
r
emedy
SAB 1000