How To Clean The Motor Filter; How To Replace The Brushes - Alto Clarke CombiVac 12 Manual Del Usuario

Figure 16
Figure 17
Page 24

How To Clean The Motor Filter

Clean the motor filter whenever it is dirty. To clean the
motor filter, follow this procedure:
1. Open the tank assembly.
2. Remove the filter bag.
3. Remove the filter, see figure 16.
4. Wash the filter in water.
5. Put the filter in a cloth and apply pressure to dry
the filter.
6. Replace filter
CAUTION: Check the motor protection filter
while changing the paper bag. Please change
the motor protection filter after use of 6 paper
bags.
7. Install the filter bag.
8. Close the tank assembly.

How To Replace The Brushes

1. Put the machine on its side.
2. Turn the knobs which secure the nozzle plate.
See figure 17.
3. Remove the nozzle plate.
4. Remove the brush assembly.
5. Install the new brush assembly.
6. Install the nozzle plate, and screws.
7. Put the machine on its wheels.
WARNING: To reduce the risk of injury from
moving parts, unplug before servicing.
ATTENTION: Pour ériter d'être blessé pour les
piéces en mouvement, débiancher avant la
maintenance.
®
Clarke CombiVac 12 & 14 Operator's Manual