Basic Safety Instructions - R&S ENY-ITS Manual Del Usuario

DANGER DANGER indicates a hazardous situation which, if not avoided, will result in death or
serious injury.
WARNING WARNING indicates a hazardous situation which, if not avoided, could result in death or
serious injury.
CAUTION CAUTION indicates a hazardous situation which, if not avoided, may result in minor or
moderate injury.
NOTICE NOTICE indicates a property damage message.
In the product documentation, the word ATTENTION is used synonymously.
These tags are in accordance with the standard definition for civil applications in the European Economic
Area. Definitions that deviate from the standard definition may also exist in other economic areas or
military applications. It is therefore essential to make sure that the tags described here are always used
only in connection with the related product documentation and the related product. The use of tags in
connection with unrelated products or documentation can result in misinterpretation and thus contribute to
personal injury or material damage.
1. The product may be operated only under the
operating conditions and in the positions
specified by the manufacturer. Its ventilation
must not be obstructed during operation.
Unless otherwise specified, the following
requirements apply to Rohde & Schwarz
products:
prescribed operating position is always with
the housing floor facing down, IP protection
2X, pollution severity 2, overvoltage category
2, use only in enclosed spaces, max.
operation altitude 2000 m above sea level,
max. transport altitude 4500 m above sea
level.
A tolerance of ±10% shall apply to the
nominal voltage and of ±5% to the nominal
frequency.
2. Applicable local or national safety
regulations and rules for the prevention of
accidents must be observed in all work
performed. The product may be opened only
by authorized, specially trained personnel.
Prior to performing any work on the product
or opening the product, the product must be
disconnected from the supply network. Any
adjustments, replacements of parts,
maintenance or repair must be carried out
only by technical personnel authorized by
1171.0000.42-04.00
Grouped Safety Messages
Tags and their meaning

Basic safety instructions

3. As with all industrially manufactured goods,
4. If products/components are mechanically
Rohde & Schwarz. Only original parts may
be used for replacing parts relevant to safety
(e.g. power switches, power transformers,
fuses). A safety test must always be
performed after parts relevant to safety have
been replaced (visual inspection, PE
conductor test, insulation resistance
measurement, leakage current
measurement, functional test).
the use of substances that induce an allergic
reaction (allergens, e.g. nickel) such as
aluminum cannot be generally excluded. If
you develop an allergic reaction (such as a
skin rash, frequent sneezing, red eyes or
respiratory difficulties), consult a physician
immediately to determine the cause.
and/or thermically processed in a manner
that goes beyond their intended use,
hazardous substances (heavy-metal dust
such as lead, beryllium, nickel) may be
released. For this reason, the product may
only be disassembled, e.g. for disposal
purposes, by specially trained personnel.
Improper disassembly may be hazardous to
your health. National waste disposal
regulations must be observed.
Sheet 2