Installation Instructions - Swann SWWHD-FLOCAM Guia De Inicio Rapido

INSTALLATION INSTRUCTIONS

This unit is designed to be mounted on a standard wiring junction box and requires
connection to a 100-240VAC power supply. For optimum results, install the unit at least
2.4m (8ft) above the ground.
Read "IMPORTANT SAFETY INSTRUCTIONS" and "PRE-INSTALLATION CHECK", and make
sure the installation site is Wi-Fi ready before installing the unit.
INSTALLATION AND WIRING MUST BE CARRIED OUT BY A LICENSED ELECTRICIAN.
IMPORTANT! TURN POWER OFF AT CIRCUIT BREAKER OR FUSE BOX.
When installing the unit refer to the Installation Example Diagram on page 6.
1 Cut a small entry hole in the cable grommet enabling the electrical supply cable to
enter the provided junction box. Make sure the supply cable coming from the wall is
long enough to route through the cable grommet to the terminal block.
2 Attach the junction box securely to the wall using the appropriate fixings for the wall
type.
3
Peel the backing off the adhesive foam gasket and stick it to the back of the floodlight
unit.
7
Englis h
EN