Single Mode; Group Mode - Stobag SKIMY SRCU 80M Instrucciones Y Advertencias Para La Instalación Y El Uso

• Transmitter potential in
automation control
The transmitter can control all automa-
tions with two different operating modes,
defined in this manual with the terms: "Sin-
gle Mode" and "Group Mode".

– SINGLE MODE

➋
(Fig. , above)
This mode enables the user to control each
automation independently and autono-
EN
mously, as each automation is associated
with a "Number", from 01 to 80 (shown on
the right of the display).

– GROUP MODE

➋
(Fig. , below)
This mode enables the user to use a sin-
gle control to simultaneously move all auto-
mations entered in a specific Group. Each
Group is represented by a "Number", from
01 to 70 (shown on the left of the display).
• Transmitter activation and
shutdown
When keys – , + , OK are pressed, the
transmitter switches on for a few seconds
56
only, after which it turns off automatically if
no other key is pressed.
• Warnings for installation and
programming
All programming sequences described with
numbers 01. 02. 03. etc... must be per-
formed in consecutive steps, and therefore
with the transmitter constantly on. As the
transmitter only switches on for a few sec-
onds if only one key is pressed, the entire
programming sequence should be read in
advance, to facilitate subsequent applica-
tion, with the aid of the illustrative exam-
ples.
Note: if the transmitter turns off, only the
last incomplete action needs to be repeat-
ed, as the previous operations are memo-
rised automatically.