Before Starting - Stobag SKIMY SRCU 80M Instrucciones Y Advertencias Para La Instalación Y El Uso

INSTALLATION
(for installation engineers)

BEFORE STARTING:

A)- To ensure simple and effective instal-
lation, first read the section "Useful tips
and warnings" and then these instructions,
strictly observing all steps and sequences
during installation.
B)- The transmitter is compatible with all
STOBAG receivers operating at the fre-
quency of 433.92 MHz. It is therefore
important to check the radio code of your
receivers, comparing each one with the
➌
data in the table in Fig. .
C)- With reference to Step 1, more than
one automation can be associated with
the same Number, but only provided
that the Receivers of these automations
have the same type of radio code (see
➌
table in Fig. ). This operation is only
recommended when the number of auto-
mations to be controlled is greater than
that admitted on the transmitter. Other-
wise, this operation is not recommended
as it limits potential and flexibility of the
entire system.
Radio codes in
Receivers
For automations of awnings
A
and shutters
— Step 1
COLLECTING DATA FOR
INSTALLATION
In this step, specific data needs to be
acquired regarding all automations to be
controlled by the transmitter. Therefore,
with reference to the example in Fig.
the table "Automation List" at the end of this
manual, and enter the following data:
Automation Name
Awning I
Awning II
Terrace awning
Garage door
3
Kitchen shutter
Living room shutter
etc...
—
➍
, use
EN
No. Code
01 A
02 A
03 A
04 A
05 A
06 A
..... .....
4
59