Stobag SKIMY SRCU 80M Instrucciones Y Advertencias Para La Instalación Y El Uso página 60

• the Name of each automation to be
controlled;
• a Number, between 01 and 80, which
from then on will identify the correspond-
ing automation/s;
• the Letter ( ) corresponding to the Radio
Code used by the Receiver of each auto-
mation.
Note: For this data, consult the table
➌
in Fig. .
EN
IMPORTANT!: All data written in the
table "Automation List", will be used
to ensure correct completion of the pro-
cedures in this manual.
60
— Step 2 —
MEMORISING THE RECEIVER RADIO
CODES IN THE TRANSMITTER
In this step the type of radio code, used
by each of the Receivers installed in your
automations, needs to be memorised on
the transmitter. Therefore, with reference
to the data in your "Automation List", pro-
ceed as follows:
01. With the transmitter switched off,
press and hold the key OK for ap-
prox. 10 seconds, until the display
shows the symbol - - - , (after
the text "PROG") then release the key
immediately.
02. Press keys – / + to select the Number
related to the automation to be pro-
grammed.
03. Press keys ▲(1) / ▼(3) to select the
Letter (radio code) associated with the
selected automation, as specified in
your "Automation List".
04. Then press one of the keys – / + to
memorise the entered data. Note: This
operation also automatically selects
the Number of the previous (or next)
automation, which is then ready to be
programmed.
Repeat the procedure described in points
03 and 04 to memorise the radio codes
of the other automations specified in your
"Automation List".
At any time, or at the end of all operations,
the user can exit the procedure by press-
ing ■(2), or by waiting for the transmitter to
switch off automatically.
– See summarised
example in Fig.
➎
–