Stobag SKIMY SRCU 80M Instrucciones Y Advertencias Para La Instalación Y El Uso página 65

text "PROG" then release the key
immediately.
02. Now use the keys – / +, to select the
NUMBER to assign to the Group, as
entered in the table.
Our example: NUMBER 03
–– Press OK to confirm the selection: the
automation Number is then shown on
the right of the display.
AUTOMATIONS
Awning I
Awning II
Terrace awning
Garage door
Kitchen shutter
Living room shutter
etc... etc...
03. Then use keys – / + to select the
Number of the first automation to be
included in this Group.
Our example: Number 05
–– Press OK to confirm the selection:
the number stops flashing once it has
been entered in the Group.
04. Then use keys – / + to select the
Number of the second automation to
GROUPS
N° 01 02 03 04 .... .... ....
01
02
03
04
05
06
.... ....
be included in this Group.
Our example: Number 06
–– Press OK to confirm the selection:
the number stops flashing once it has
been entered in the Group.
Note: If the
to the next paragraph AUTOMATIONS
CONNECTED TO A BRIGHTNESS
SENSOR.
At this point the creation of Group 03, in
our example is complete.
To proceed with the creation of another
Group, before the transmitter switches
.. . ...
off, press key ■(2) and repeat the above
procedure, starting from point 02.
It is possible to exit this procedure at the
end of all operations or at any other time by
simply waiting for the transmitter to switch
off automatically.
8
, symbol appears, refer
– See summarised
➒
example in Fig. –
EN
65