Product Setup; Hardware Setup - D-Link DWR-925 Guía De Instalación Rápida

PRODUCT
SETUP

HARDWARE SETUP

Ensure that your DWR-925 is powered off before performing the steps below.
1. Unscrew the metal plate on the front of the router and insert a standard U(SIM)
card into the SIM card slot with the gold contacts facing upward.
2. Insert your Internet/WAN network cable into the WAN port on the back of the
router.
Note: The 4G connection can also be used as a backup WAN. Once a backup is configured,
if the Ethernet WAN is not available the router will automatically use 4G for the Internet
connection.
3. Insert the Ethernet cable into the LAN Port 1 on the back panel of the DWR-925
and an available Ethernet port on the network adapter in the computer you will use to
configure the unit.
Note: The DWR-925 LAN Ports are "Auto-MDI/MDIX." Therefore, patch or crossover Ethernet
cables can be used.
4. Connect the power adapter to the socket on the back panel of your DWR-925. Plug the other
end of the power adapter into a wall outlet or power strip.
a. The Status LED will light up to indicate that power has been supplied to the router.
b. The LEDs on the front panel will flash on and off as the DWR-925 performs initialization
and Internet connection processes.
c. After a few moments, if a connection has been established, the following LEDs will turn
solid green: Power, Status, WAN, WLAN, and LAN Port 1 (or whichever port(s) your
Ethernet cable has been connected to).
ADVANCED SETUP (ACCESS VIA IP ADDRESS)
Open a browser window and enter the IP address below into the browser address field.
Log in using the username and password below.
DWR-925
IP ADDRESS: http://192.168.0.1
USERNAME: admin
PASSWORD:
SIM card
3