Use Of Payment Systems Mdb - FAS International SPIRALI HDR Manual Del Usuario

Spirali HDR Panzer - Issue 00
9.4

USE OF PAYMENT SYSTEMS MDB

Installation: The coin mechanism MDB has to be connected to the connector J4 of the control card (see
figure). The command 69 has to be programmed to value 5, then turn off the machine for some seconds.
By putting it on again the machine and the coin mechanism will comunicate correctly. There are the following
additional commands for the use of these payment systems:
Setting the signal for payment system out of order.
Command 27
Command 28 Select change giving tube content counter.
Command 29 Cashless credit cannot be displayed.
Command 30 Purchase obligation before return.
Command 31 Sets the max. accepted credit.
Command 33 Inhibits single coins.
Command 34 Inhibits coins during exact amount.
Command 35 Resetting coin meters in change giving tubes.
Command 36 Condition exact amount (no coins available for change).
Command 37 Inhibits note validator during exact amount.
Command 38 Emptying of change giving tubes.
Filling in of the change giving tubes.
Command 39
Command 27 Setting the signal for payment system out of order:
To set the following option ONLY, enter the "programming mode" and when the
message "command 00" appears on the display press the "test" button again for a
further 3 seconds, after which the buzzer will sound again for a few seconds, and
access to the second level of the menu is obtained. The message "Command 00" will
appear again. To quit the programming mode press the "A" key .
If the command is set at 1, when the connection with the MBD payment system is interrupted the vending
machine goes out of order and the message appears on the display; if the command is set at 0 (zero), the
option is disabled. The default setting is 0.
Command 28 Select change giving tube content counter:
This command allows the user to select whether to use the counters corresponding to the content of the coin
mechanism change giving tube or use only the counters inside the machine. If the command is set at 1 at
each power-up the counters inside the machine which correspond to the content of the change giving tubes
are updated with the values transmitted by the coin mechanism. If, on the other hand, the command is set at
0 the values transmitted by the coin mechanism are ignored.
Command 29 Cashless credit cannot be displayed:
This command allows the user to prevent or enable display of credit from the MDB cashless device (key or
card reader). If the command is set at 1 the credit corresponding to the cashless device is not displayed,
whereas if the command is set at 0 the machine also displays the credit available on the cashless device.
Command 30 Purchase obligation before return:
By setting this command to 1 the customer is obliged to purchase before receiving back the return. This is to
avoid to use the coin mechanism as a coin-changer. If the purchase fails to happen, the return will be given
out.
Command 31 Sets the max. accepted credit:
It sets the max. credit accepted by the coin mechanism. When this value is overtaken, the acceptance of
other coins/notes is blocked.
Command 33 Inhibits single coins:
This command blocks the acceptance of particular coins by the coin mechanism. To block the acceptance of
coin 5 proceed as follows:
1. Go into programming mode to display .....................................................................................Command 00
2. Key in 33 and press B to display.................................................................................................Coin No. 00
3. Key in 5 and press B to display....................................................................................................................1
4. Key in 0 and press B.
N.B.: To activate the possible modifications of command 33, turn the machine off and then on after
modification itself.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
31
E
N
G
L
I
S
H