MAINTENANCE
LUBRICATION:
The treadmills have already been spread with "Silicone Oil" in advance before leaving the manufacturing plant. Silicone oil
is without volatility and has gradually permeated through the running belt.
Lubrication must be applied all 50 working hours.
NOTE: Only use "Silicone Oil" lubricants for this equipment. In addition, do not add any other oil
ingredient; otherwise the treadmill will be damaged. Do not over-lubricate the walking board. Excess
lubricant should be wiped off with a clean towel.
TROUBLESHOOTING GUIDE
Problem
Possible Causes
E01
Console communication failures
E02
Motor failure
E03
Speed sensor failure
E04
Motor Circuit disconnection
E05
Over current protection
E06
The supply voltage is too low
E07
Check the safety lock
Note
Drives do not receive a digital signal
With inductive drive
44