Device Install - C2G 29510 Manual De Instalación

Device Installation (US)
Note:
Prior to the installation, ensure to power off all devices that will be connected to this system. Ensure that all devices you will connect are properly grounded.
Place cables away from fluorescent lights, air conditioners and machines that are likely to generate electrical noise. Allow adequate space around the unit
for air circulation.
Grounding: To prevent any damage to the product or any connected devices, and to improve audio/video signal quality, it is important to ensure that the
extender systems are properly grounded.
Transmitter Unit
Step 1. Use a HDMI cable to connect the source device to the port labeled HDMI IN on the transmitter unit.
Step 2. Use the supplied mini-USB to USB-A cable to connect the mini-USB port on the transmitter unit, and the USB-A port of the source device.
Step 3. Use a 3.5mm audio cable to connect the port labeled STEREO IN on the transmitter and the 3.5mm audio output port of a source device (if needed)
Step 4. Use a TOSLINK cable to connect the port labeled TOSLINK IN on the transmitter & and the TOSLINK output port of a source device (if needed)
Step 5. Connect a supplied RJ11 to DB9 adapter to a supplied RJ11 serial extension cable, connect the RJ11 connector of the RJ11 serial extension cable to
the port labeled RS232 on the transmitter, and connect the DB9 connector of the RJ11 to DB9 adapter to a DCE (if needed)
Step 6. If choosing to connect the supplied IR receiver to the port labeled IR IN on the transmitter unit, then please connect the supplied IR transceiver to the
port labeled IR OUT on the receiver unit. Otherwise, connect the supplied IR transceiver to the port labeled IR OUT on the transmitter unit, then connect the
supplied IR receiver to the port labeled IR IN on the receiver unit.
Step 7. Use a CAT5e/6/7 cable to connect to the RJ45 port on the transmitter & receiver. For a better EMI compliance, it's suggested to use ferrite cores to
the following places:
a.) Attach ferrite cores to both ends of the CAT cable, one for each, where the ferrite core is close to the Tx and Rx units.
b.) Attach a ferrite core to the HDMI cable in between Tx and PC, where the ferrite core is close to the Tx unit.
c.) Attach a ferrite core to HDMI cable in between Rx and monitor, where the ferrite core is close to the Rx unit.
Receiver Unit
Step 1. Connect a HDMI display to the port labeled HDMI OUT on the receiver unit using a HDMI cable.
Step 2. Connect all peripheral USB devices to USB-A port on the receiver unit. (if needed)
Step3. Use a 3.5mm audio cable to connect the port labeled STEREO OUT on the receiver and the 3.5mm audio input port of a display or a speaker. (if
needed)
Step 4. Use a TOSLINK cable to connect the port labeled TOSLINK OUT on the receiver & and the TOSLINK input port of a display or a TOSLINK source device.
(if needed)
Step 5. Connect a supplied RJ11 to DB9 adapter to a supplied RJ11 serial extension cable, connect the RJ11 connector of the RJ11 serial extension cable to
the port labeled RS232 on the receiver, and connect the DB9 connector of the RJ11 to DB9 adapter to a DTE (if needed)
Step 6. After all devices connected, apply the supplied power adapter to the transmitter unit.
Step 7. Power on the connected computer and devices.
7