Regularly
Stop the engine and unscrew the dipstick. The level should be
between FULL and ADD. NOTE: The dipstick must be screwed
all the way down in order to indicate correct oil level. Avoid
filling with too much oil.
Regelmässig
Stellen Sie den Motor ab und schrauben Sie den Ölpeilstab
heraus. De Ölstand soll swischen FULL and ADD liegen. ACH-
TUNG: Der Ölpeilstab muss vollständig hineingeschraubt sein,
damit der richtige Ölstand angezeigt werden kann. Vermeiden
Sie zu viel Öl einzufüllen.
Régulièrement
Arrêter le moteur et vérifier la jauge à julie. Le niveau doit être
situé entre FULL (plein) et ADD (ajoutez). ATTENTION: Il faut
que la jauge soit vissé à fond pour obtenir un résultat correct.
Evitez de mettre trop d'huile.
Periódicamente
Parar el motor para controlar el nivel de aceite del motor. Debe estar entre FULL y ADD. ATENCIÓN: La
tapa tiene que estar bien puesta para que la indicación del nivel de aceite de la varilla sea correcta. Evitar
relleno excesivo de aceite.
Regelmatig
Kontroleer het oliepeil bij voorkeur bij een koude motor. Het niveau moet tussen FULL en ADD staan.
Nooit beneden de ADD mar ook nooit boven FULL. N.B.: De peilstok moet geheel ingedraaid worden voor
dejuiste meting. Niet teveel olie bijvullen.
Periodicamente
Arrestare il motore e controllare l'asta dell'olio. Ll livello deve trovarsi fra FULL e ADD. ATTENZIONE:
L'asta dell'olio deve essere avvitata fino in fondo per vedere il livello correctto dell'olio. Evitare di versare
troppo olio.
Annually (After end of season)
Grinding and balancing the cutter blade. Remove the spark
plug lead. Fitting and removing the blade require the use of
protective gloves. Unscrew the cutter blade and deliver it to a
service workshop for grinding and balancing. Tighten the screw
properly when re as sem bling.
Jährlich (nach Beendigung der Saison)
Schleifen und Auswuchten des Messers.
Demontage des Messers Zündkabel von der Zündkerze
entfernen). Die Klinge nur mit Schutzhandschuhen einsetzen
und entfernen. Schrauben Sie das Messer ab und bringen die-
ses in eine Service-Werkstatt. Bei der Montage die Schrauben
richtig anziehen.
Annuellement (à fin de la saison)
Aiguisage et équilibrage de la lame. Débrancher la bougie. Mettre des gants de protection avant de
mettre en place ou d'enlever la lame. Démontez-la et donnez-la à aiguiser à un professionnel. Bien
resserer la vis après remontage.
Revisión anual (Al terminar la estación)
Afilado y equilibrado de la cuchilla. Se desconecta el cable del encendido de la bujía. El ajuste y la
sustitución de la hoja requiere el uso de guantes protectores. Se desmonta leugo la cuchilla que es entrega
a un taller mecánico para su afilado y equilibrado. Apriétese bien la tuerca al volver a montar.
Jarlijks (na einde van het seizoen)
Slijpen en balanceren van het maaimes. De bougiekabel losmaken. Bij het afstellen en verwijderen van
het mes moeten altijd beschermende handschoenen worden gedragen. Schroef het mes er af en breng het
naar de werkplaats voor slijpen en balanceren. Bij het weer aanbrengen de schroef goed vastdraaien.
Controllo annuale (All fine della stagione)
Rettifica e bilanciamento della lama. Rimuovere il cavo di accensione. Inserire e rimuovere la lama
solamente indossando guanti di protezione. Smontare la lama e consegnarla ad una officina di servizio
per la rettifica ed il bilanciamento. Stringere bene le viti nel rimontaggio.
(Achtung: Vor
18
Safe Operation Prac tic es for Pe des tri an-Controlled Rotary Lawnmowers
IMPORTANT: This cutting machine is ca pa ble of am pu tat ing hands and feet and throwing objects.
Failure to observe the following safety instructions could result in serious injury or death.
I.
Training
• Read the instructions carefully. Be fa mil iar with the
con trols and the proper use of the equipment.
• Never allow children or people un fa mil iar with the
ins truc tions to use the lawnmower. Local regulations
may restrict the age of the operator.
• Never mow while people, especially children, or pets
are nearby.
• Keep in mind that the operator or user is responsible
for accidents or hazards occurring to other people or
their property.
II. Preparation
• While mowing, always wear sub stan tial footwear and
long trousers. Do not operate the equipment when
barefoot or wearing open sandals.
• Thoroughly inspect the area where the equipment
is to be used and remove all objects which may be
thrown by the machine.
• WARNING - Petrol is highly flammable.
- Store fuel in containers specifically de signed for
this pur pose.
- Refuel outdoors only and do not smoke while re fu -
el ing.
- Add fuel before starting the engine. Never remove
the cap of the fuel tank or add petrol while the engine
is running or when the en gine is hot.
- If petrol is spilled, do not attempt to start the engine
but move the ma chine away from the area of spill-
age and avoid cre at ing any source of ig ni tion until
petrol va pors have dis si pat ed.
- Replace all fuel tanks and container caps se-
cure ly.
• Replace faulty silencers.
• Before using, always visually inspect to see that the
blades, blade bolts and cutter assembly are not worn
or dam aged. Replace worn or damaged blades and
bolts in sets to pre serve balance.
• On multi-bladed machines, take care as rotating one
blade can cause other blades to rotate.
III. Operation
• Do not operate the engine in a confined space where
dan ger ous carbon mon ox ide fumes can collect.
• Mow only in daylight or in good artificial light.
• Avoid operating the equipment in wet grass, where
feasible.
• Always be sure of your footing on slopes.
• Walk, never run.
• For wheeled rotary machines, mow across the face
of slopes, never up and down.
• Exercise extreme caution when chang ing direction
on slopes.
• Do not mow excessively steep slopes.
• Use extreme caution when reversing or pulling the
lawnmower towards you.
• Stop the blade if the lawnmower has to be tilted for
trans por ta tion when cross ing surfaces other than
grass, and when transporting the lawnmower to and
from the area to be mowed.
• Never operate the lawnmower with defective guards, or
without safety de vic es, for example deflectors and/or
grass catchers, in place.
• Do not change the engine governor settings or over-
speed the engine. Op er at ing the engine at excessive
speed may increase the hazard of personal injury.
• Disengage all blade and drive clutches before starting
the engine.
• Start the engine or switch on the motor carefully ac-
cording to instructions and with feet well away from
the blade.
• Do not tilt the lawnmower when starting the engine or
switch ing on the motor, except if the lawnmower has
to be tilted for starting. In this case, do not tilt more
than absolutely nec es sary and lift only the part which
is away from the op er a tor.
• Do not start the engine when standing in front of the
discharge chute.
• Do not put hands or feet near or under rotating parts.
Keep clear of the dis charge opening at all times.
• Never pick up or carry lawnmower while the engine
is running.
• Stop the engine and disconnect the spark plug
wire:
- before cleaning blockages or un clog ging chute;
- before checking, cleaning or work ing on the lawn-
mower;
- after striking a foreign object. Inspect the lawnmower
for damage and make repairs before re start ing and
op er at ing the lawnmower;
- if the lawnmower starts to vibrate abnormally (check
im me di ate ly).
• Stop the engine:
- whenever you leave the lawnmower;
- before refuelling.
• Reduce the throttle setting during en gine shut down
and, if the engine is provided with a shut-off valve,
turn the fuel off at the conclusion of mowing.
• Go slow when using a trailing seat.
IV. Maintenance and Storage
• Keep all nuts, bolts and screws tight to be sure the
equip ment is in safe work ing condition.
• Never store the equipment with petrol in the tank inside
a building where fumes may reach an open flame or
spark.
• Allow the engine to cool before storing in any enclo-
sure.
• To reduce the fire hazard, keep the engine, silencer,
battery compartment and petrol storage area free of
grass, leaves, or excessive grease.
• Check the grass catcher frequently for wear or de te -
ri o ra tion.
• Replace worn or damaged parts for safety.
• If the fuel tank has to be drained, this should be done
outdoors.
3