Welding Process - Abicor Binzel ABIROB A Instructivo De Servicio

®
ABIROB A
7 Operation
DANGER
Shortness of breath and poisoning caused by inhaling phosgene gas
When welding workpieces that have been degreased with chlorinated solvents, phosgene
gas is formed.
• Do not inhale fumes and vapors.
• Ensure a sufficient supply of fresh air.
• Rinse the workpieces with clean water prior to welding.
• Do not place degreasing baths containing chlorine in the vicinity of the welding area.
DANGER
Risk of burns
During welding activities, sparks, glowing workpieces or hot slag can produce flames.
• Check the work area for flashpoints.
• Provide appropriate fire extinguishing equipment in the workplace.
• Allow workpieces to cool down after welding.
• Prior to performing welding work, properly fasten the ground clamp to the workpiece or
welding table.
WARNING
Arc eye
The arc produced by welding can damage the eyes.
• Check and wear your personal protective equipment.
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Ensure that all required parameters have been set.

7.1 Welding process

1 Open the shielding gas cylinder.
2 Switch on the power source.
BAL.0125 • 2019-04-15
7 Operation
EN - 15