Part 2. Preparation; Supplied Items; Interconnections - Sony SDT-S9000 Guia Del Usuario

Part 2. Preparation

Supplied Items

Interconnections

After you confirm that you have all of the required accessories for your
installation, connect the drive to the host computer, and select the SCSI ID
with the rotary switch on the rear panel.
When you first open the box, make sure it contains the following items.
Contact your supplier if anything is missing or broken.
• DDS Drive Unit
• Power Cable
• This Guide
The SCSI bus allows connection of up to seven peripherals to the host
computer. Use a SCSI cable with a full-pitch connector.
Precautions
• Switch off the host computer and peripherals before connecting the SCSI
cable.
• Make sure the SCSI connectors are pressed tightly together.
• If this unit is the last (or only) device on the SCSI bus, make sure to connect
a SCSI bus terminator to the open connector.
• The total length of the SCSI cable(s) between the host computer and the last
device should be less than 6 meters.
*1
When using high-speed data transfer with the SDT-S9000/S7000/S7200, it is recommended
that total length of the SCSI cable not exceed 3m.
*1
SCSI CONNECTOR
Figure 2-1 Interconnections
AC IN
SCSI ID GND
AC power
13
Part 2. Preparation