Important Safety Instructions; Agency Approvals; Product Overview; Specifications - BriskHeat PTBO-GET Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS

DANGER
A person who has not read and
understood all operating
Instructions is not qualified to
operate this product.
DANGER

Do not immerse junction box in liquid.

Keep volatile or combustible material away from
junction box when in use.

Use junction box only in approved locations.

Keep sharp metal objects away from junction box.
Failure to observe these warnings may result in electric
shock, risk of fire, and personal injury.
WARNING
End-User Must Comply to the Following:

Only qualified personnel are allowed to connect
electrical wiring.

Disconnect all supply power at the source before
making any power connections.

All electrical wiring must follow local electrical
codes and highly recommend following NEC
Article 427.

The person who performs the final installation /
wiring must be qualified for this work.

The end-user is responsible for providing a
suitable disconnecting device.

The end-user is responsible for providing suitable
electrical protection device. It is highly
recommended that a ground fault circuit breaker
be used.
Failure to observe these warnings may result in personal
injury or damage to the product and/or property.
®
© BriskHeat Corporation. All rights reserved.
PTBO-GET Octagon Hinged-Cover
Junction Box Power Connection Kit

Agency Approvals

For SLCBL -BP, -BF Series only
Class I, Div. 2 , Groups A, B, C, D
Class II, Div. 2 , Groups E, F, G
Class III
Approvals valid only when installed in accordance with
all applicable instructions, codes, and regulations.
CAUTION

Inspect all components before use.

Do not use junction box if any component is
damaged.

Do not repair a damaged or faulty component.

Do not crush or apply severe physical stress on
any component of system, including cord
assembly.

Unit must be mounted away from vibration,
impacts, water and corrosive gases.

Do not operate junction box above rated
temperature value.

Fasten junction box to device using approved
methods only.
Failure to observe these warnings may result in personal
injury or damage to the product and/or property.
3

PRODUCT OVERVIEW


The JHS-GET is designed for use with BriskHeat SLCBL / SLMCBL / SLHCBL series
heating cables in ordinary locations only.

The JHE-GET kit is approved by CSA for use in hazardous area locations with SLCBL
series heating cable only.

The PTBO-GET is rated NEMA 4X.

Earth Continuity Plate included.

SPECIFICATIONS


Operating temperatures: -40°F to 122°F (-40°C to 50°C)

Approximate volume: 38.75 in³ (635 cm³)

Material: Fire Retardant FRP Composite Polymer

Special feature: The enclosure has a uniquely designed hinged cover for added
convenience during installation.

Maximum current: 32A

Voltage: 110-120V, 208-277V

Maximum Continuous Exposure Temperature (T5): 212°F (100°C)
DIMENSIONS
®
© BriskHeat Corporation. All rights reserved.
PTBO-GET Octagon Hinged-Cover
Junction Box Power Connection Kit
4