Brightwell Brightstar II Manual De Instrucciones página 16

I
NSTALLATION
In some cases, the solenoids in the host machine are
machines is not linked via a common wire to the other solenoids.
If this is the case, the signal
of the appropriate link (LK7 to LK16, or LK1 to Lk6 on 1-6 pump boards). If in doubt remove the appropriate link for each
incoming signal source.
FAILURE TO REMOVE THE APPROPRIATE LINK WOULD RESULT IN UNIT FAILURE.
DO NOT ATTEMPT TO REMOVE LINKS WHEN THE POWER IS ON.
Note:
If a signal is applied to Input 2 before Input 1 then the unit will assume that a Pre-wash is not occurring and will ignore
subsequent signals to Input 1 until the unit has reset.
RP1, RP2, RP3 & RP4
Remove to allow signals range
of 12V - 240V AC or DC
(RP1 & RP2 only on
1-6 pump boards)
Note:
7-10 Pump board shown. 1-6 Pump units will only have 6 inputs, 6 links & 2 resistor packs.
B L S
RIGHTSTAR AUNDRY YSTEMS
-
W 2
IRING
must
be isolated from the common B rail on the I/O Board or Driverboard. This is done by removal
1 2
RP1
P7
LK8 LK9
LK7
1
2
Signal Inputs
90V - 240V AC or DC
B Rail
(Negative)
The negative The positive (live)
(neutral) signal from signal from each
each input must be input must be taken
taken to the relevant to the relevant
connection on the B connection on the A
Rail.
Separate
connections are connections are
provided on input 2 provided on input 2
for Hot & Cold wash for Hot & Cold wash
signals.
Example sources: -
Interface Board
Solenoid Valves
not For example
common.
LK7 - LK16 (10 Pk = XSP-09-071)
3 4 5 6 7 8
P9
LK10 LK11 LK12 LK13
3 4 5 6 7 8
A Rail
(Positive)
Rail.
Separate
signals.
15
: The softener solenoid on some Miele
Remove to isolate signals
from the B Rail
RP4 L1
9 10
B
C24
RAIL
L
LK15 LK16
LK14
L N
9 10
P10
A
RAIL
90V - 265V AC 50/60Hz
230V AC 50/60Hz
Sourced from a point, which is
isolated when the host machine is off
Example
INPUT 1 - Pre-Wash
INPUT 2 - Main-Wash
(Cold Solenoid)
INPUT 2 - Main-Wash
(Hot Solenoid)
INPUT 3 - Fabric Softener
COMMON
Recommended Wiring
Max Size =
1.5mm²
Min Size = 0
.5mm²
Current = 0.5A
E
NGLISH
SEC
24V IN
P5
PRIM
24V
N
IN
(BSL & BSML DC Units)
(BSHL & BSML AC Units)
B L S
RIGHTSTAR AUNDRY YSTEMS