Storage - Snapper 2691525-00 Manual Del Operario

7. Install the filter on the intake. Push the end of the filter
into the base as shown. Make sure filter fits securely in
the base.
8. Install air filter cover and secure with fasteners.
39
Engine Adjustments and Repairs
Engine adjustments and/or repairs should be performed by an
authorized dealer.

Storage

Note: If desired, the Rear Engine Rider can be stored on the
rear bumper.
1. Thoroughly clean the unit by removing all grass clippings
and debris.
2. Perform maintenance and lubrication as required.
3. Drain the fuel from the fuel tank (unless using a fuel
stabilizer - see Storage - Fuel System).
4. Start the engine and allow it to run until the engine runs
out of fuel. This allows the carburetor and fuel system to
remain clean during storage.
5. Remove the battery. See Cleaning the Battery and
Cables.
6. If desired, carefully stand the Rear Engine Rider on its
rear bumper in the desired location for storage.
22
Storage - Fuel System
Fuel can become stale when kept in a storage container for
more than 30 days. Each time you fill the container with fuel,
®
add STA-BIL 360° PROTECTION™ to the fuel as specified
by the manufacturer's instructions. This keeps fuel fresh and
decreases fuel-related problems or contamination in the fuel
system.
It is not necessary to drain fuel from the engine when STA-
®
BIL 360° PROTECTION™ is added as instructed. Before
storage, turn the engine ON for 2 minutes to move the fuel
and stabilizer through the fuel system.
Before Starting the Machine After it Has
Been Stored
• Check all fluid levels.
• Check all maintenance items.
• Perform all recommended checks and procedures found
in this manual.
• Allow the engine to warm up for several minutes before
use.