Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Rear Panel
1
1.
Power Input: Connect the included power cable here.
2.
Power Amplifier Output: This sends the master signal to your loudspeaker. 4 –
32 ohms, 70 V, and 100 V connections are provided. Connect this to your
loudspeaker using a properly terminated 4-pin Euroblock connector and
appropriately sized wire. See the section Operation > Euroblock Setup for
more information.
Note: This output always provides a mono signal.
3.
Master Output: Connect this balanced mono XLR output to a powered
speaker.
Note: This output is always summed to a mono signal.
4.
USB LED: This LED will illuminate when the USB port is connected to a
computer's USB port.
5.
USB Port: Connect a USB cable from here to a computer's USB port for audio
playback and recording.
Note: This output always provides a mono signal.
6.
1/8" (3.5 mm) TRS Input: Connect a line-level device such as a smartphone,
tablet, CD player, etc. here.
Note: Connecting to this jack disconnects USB input (playback). USB output
(recording) is unaffected. This allows for recording of three Bluetooth signals
and the 1/8" (3.5 mm) TRS input to the computer using the USB port.
7.
Bluetooth Antenna: Connect the 3 included Bluetooth antennas here for
pairing to Bluetooth sources.
8
5
2
3 4
6
7
Publicidad
Tabla de contenido
