Rane BLACK&BLUE Guia Del Usuario página 9

Operation
Pairing Bluetooth Sources
1. Connect the 3 included Bluetooth antennas to the connectors on Black & Blue's
rear panel.
2. Power on Black & Blue. The power LED will illuminate solid.
3. Press and hold the Pair button for 3 seconds for the particular Bluetooth input
you desire to connect to for your Bluetooth source. The Pair LED will flash.
4. Pair your Bluetooth source to Black & Blue.
a. Smartphone: open Bluetooth settings in your smartphone, find Black &
Blue-A, and connect. The pair LED on Black & Blue will be lit solid when
connected.
b. Bluetooth headset mic: turn on the headset mic. The mic LED will flash
quickly when searching for Black & Blue. When paired successfully, the
mic LED will flash slowly and Black & Blue's pair LED will be lit solid.
Note: Bluetooth audio cannot be sent to a headset's headphones.
Bluetooth audio will only be sent from a Bluetooth headset's microphone to
Black & Blue.
To disconnect from a Bluetooth source, press and hold the Bluetooth input's Pairing
button for 3 seconds.
Note: If the mic connects with a different Bluetooth source which is not desired (for
example, Black & Blue-A), press the search button on the Bluetooth headset mic
and connect to the next Bluetooth source (Black & Blue-B or Black & Blue-C).
Note: Repeat the above steps to connect additional Bluetooth sources.
Selecting Sources
1. Connect the included Bluetooth antennas to the connectors on Black & Blue's
rear panel.
2. Press and hold the Pair button(s) for 3 seconds to connect to your Bluetooth
source(s).
3. Connect a USB cable from Black & Blue's USB port to an available USB port on
your computer.
4. Adjust the Listen To knob to select Bluetooth A, B, C, or Computer as source.
Press the Mix button to hear a blend of all sources from the Master output and
Power Amplifier output.
5. Turn the Master Volume knob to adjust the signal level sent to the Master
output and Power Amplifier output.
9